This Raspberry Pi Zero It is a powerful SBC that can run a complete operating system like a normal one raspberry pieDespite its popularity, we have not seen a new version of the pocket board for a while, and manufacturers are eager for new features. Nevertheless, it is difficult to slow down a dedicated community like the Pi community. Today we will share the awesome USB Type-C Pi Zero upgrade developed by the Mcllrn manufacturer.
This is not the first Mcllrn project we have shown.They will recently CPU becomes a button,(This is not very practical, nor is it something we recommend, but some The best Raspberry Pi project is it you can do, no should do).
The mod is quite simple and can be completed almost without welding. The USB 3.1 Type-C connector is soldered to the male mini JST connector. There are test pads on the back of Pi Zero, and you can solder the female mini JST connector to it, but you can also use pins to connect it.In this case, Mcllrn’s project uses a Pimoroni ink PHAT, It encapsulates GPIO, so another solution is needed.
Before heating the soldering iron, please note that there is no voltage adjustment for this setting. According to Mcllrn, the rig works well on a 5V charger, but pushing too much juice into it is likely to blow up your Pi.
To take a closer look at this project, please visit the original Reddit Wire For more details, be sure to follow Mcllrn for future Pi projects.